Create FRIDGE RETRO Mode D'emploi page 8

D OOR HA N D LE I NSTAL L ATI ON
The door handle comes detached due to packaging
restrictions. It can be easily attached following the in-
structions.
• Fix the two screws (1) to the door.
• Insert the two fixed screws into the two holes on the
metal handle (2).
• Fasten the two screws (3) to the bottom of the handle.
F RI D G E I N STA L L ATI ON
Before installing your new fridge, read all of the safety guidelines in this manual and then fol-
low the instructions below:
1. Place the fridge on a sturdy, level floor for quieter operation. Ensure that the floor is strong
enough to support the fridge when it is fully loaded.
2. If the refrigerator is to be placed on a carpet, put a wooden board in between the fridge and
the carpet. Be aware that, by placing the refrigerator on top of a carpet, the heat from the
compressor may cause the carpet to fade.
3. This appliance is designed to be freestanding and it should not be recessed or built-in.
4. Do not tilt the fridge more than 45° from its upright position when moving it.
5. Avoid areas where the appliance would be exposed to direct sunlight, sources of heat (stove,
heater, radiator, etc.), extremely cold ambient temperatures or excessive moisture and high
humidity. Installing it in the coolest area of the room will save energy consumption and run-
ning costs.
Handle with care! Do not apply force to any area such as the condenser or the door. The metal
rails on the bottom of the refrigerator may have sharp edges, so always unpack and handle with
care. Do not drag the unit: place it carefully into position to avoid scratching the floor.
• Place the unit so there is enough space for the door to open.
• Leave a minimum clearance of 100mm at the back of the fridge to ensure air can circulate
freely so the compressor and condenser can cool down. Also leave at least 50mm of space at
the top of the fridge and 50mm on each side.
• The appliance must be level in order to work properly. If the unit is not level, the doors and
magnetic seal alignments will not be covered properly.
• Your refrigerator has two adjustable front feet, one on the right and one on the left. In most
cases, the refrigerator should be steady when both feet are touching the floor. If your refrig-
erator seems unsteady or if you want the doors to close more easily, adjust the refrigerator's
tilt by levelling the feet.
ADJU STI N G T HE T H E R M OSTAT
• To start the refrigerator, turn the thermostat knob to the position corresponding to the desired
temperature. The temperature of the refrigerator is controlled by adjusting/setting the ther-
mostat knob, located at the top of the cabinet.
• The settings 0(OFF) - 7(MAX) regulate the internal temperature of the refrigerator.
Setting 0 (OFF): not operating (Please press the knob and turn to get the "0" position).
Setting 1 (Min.): lowest setting (warmest internal temperature).
Setting 7 (Max.): highest setting (coldest internal temperature).
NOTE: The refrigerator temperature will vary depending on the quantity of cans/bottles stored
and on the frequency with which the door is opened. The internal temperature varies in different
parts of the refrigerator. The back of the refrigerator is coldest. Please keep the cans/bottles
away from the rear wall to avoid them freezing and to allow cold air circulation.
8 E NGL I SH
SPACE REQUIREMENTS
LEVELLING
1
2
1
3
3