Create FRIDGE RETRO Mode D'emploi page 6

DA I LY U SE
• Always allow hot foods and drinks to cool to room temperature before putting them in the com-
partment.
• Store pre-packaged food according to the instructions on the label.
WARNING! Do not use mechanical, electric or chemical means other than those recommended
by the Manufacturer to speed up the defrosting process.
• Never use a sharp or metal instrument to remove frost or clean the appliance. Use a plastic
scraper, if necessary.
• Strictly follow the refrigerator's storage guidelines. Refer to relevant instructions.
• If the refrigerator is unplugged, turned off or has lost power, you must wait 3 to 5 minutes before restart-
ing the unit. If you attempt to restart it before this time delay, the refrigerator will not start.
F L A M M A B L E - RE F RI GE R A NT G AS WA RN I NG
• Danger! Risk of fire or explosion. Flammable refrigerant used. Maintenance and repair work
may only be carried out by authorised and appropriately trained personnel. Do not damage the
appliance's refrigerant circuit pipes.
• Caution! Risk of fire or explosion. Dispose of the refrigerator in accordance with federal and local
regulations. Refrigerants must be evacuated in accordance with established procedures.
Appliances with Isobutane (R600a): isobutane is a natural gas without environmental impact, but
it is flammable. Therefore, make sure the refrigerant circuit pipes are not damaged. Keep special
attention in case of damaged pipes emptying the refrigerant circuit.
WARNING: Do not damage the refrigerant circuit! Never use an appliance with a damaged re-
frigerant circuit! If the refrigerant circuit is damaged, avoid proximity to open fires and all types
of heat and sources of ignition. Thoroughly ventilate the room in which the appliance is located.
• It is hazardous for anyone other than an authorised service person to service this appliance.
• The room in which the appliance is located must be at least 1m³ per 8g of refrigerant. The amount
and type of refrigerant in the appliance can be found in the Technical Specifications.
• Do not use or place electrical devices inside the appliance compartments if they are not of the
type expressly authorised by the Manufacturer.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
• During transportation and installation of the appliance, ensure that none of the components of
the refrigerant circuit becomes damaged.
• Avoid open flames and sources of ignition.
• Thoroughly ventilate the room in which the appliance is located.
• It is dangerous to alter the specifications or modify this product in any way.
• A damaged cord can cause a short circuit, fire and/or electrical shock.
• Excessive weight hazard. Take extra care when moving the fridge to avoid any injuries. This
may require two people or mechanical aid when installing the fridge. Failure to do so can result
in back injuries, amongst others.
• Avoid prolonged exposure of the appliance to direct sunlight.
• This appliance is intended to be used indoors only.
• All electrical components (plug, power cord, compressor, etc.) must be exclusively replaced by
a certified service agent or qualified service personnel.
• DO NOT USE AN EXTENSION CORD. Plug the appliance into a grounded socket: the appliance
must be correctly connected to an approved earthing system. Do not use single/multi adapters
or extension cords.
• Make sure that the power plug is not squashed or damaged. This could lead to overheating and
cause a fire.
6 E NGL I SH