Abus TVIP52501 Manuel Utilisateur page 99

English
13.1 Trigger settings
"Video motion detection" Activate the desired motion window.
"Periodically" The event is triggered periodically. Maximum setting is 999 minutes.
"Digital input" Triggered if a signal is present at the alarm input (e.g.: door contact).
"System boot" Event is triggered when the system is rebooted (after a power failure).
"Recording notify" If the destination storage (medium) is full or if a cyclic recording is overwritten, an alarm
is triggered.
"Camera tampering detection" An alarm is triggered if the system detects that the connected analogue
camera has been tampered with.
"Video loss" An alarm is triggered if the video signal is interrupted.
"IP changed" As long as a new IP address is assigned to the network camera, an alarm is triggered.
"Video restore" Triggered when the video signal is restored following a malfunction.
99