Abus TVIP52501 Manuel Utilisateur page 68

3.3 Video output and DIP switches
Analogue video output (NTSC/PAL):
Connect the RCA connector from the video/audio cable with an analogue video input from a
monitor. (e.g.: TVAC10100)
To set the correct video norm (PAL/NTSC) please use the DIP switch on the back panel of
the camera.
External / Internal microphone (Ext. /Int.)
Use this DIP switch to change between integrated microphone and external audio input.
3.4 Gate input / output and status display
In order to reboot the camera or restore the factory settings press the reset button. Use an appropriate small
tool.
Camera reboot: Press the reset button once and wait until the camera to restart.
Restore factory settings: Press and hold the reset button for approx. 30 seconds until the status LEDs start
flashing. All settings will be reset to factory default.
Status LED description:
Status / LED colour
System start
Camera turned off
Network works (heartbeat)
Network problem
Firmware update
Restoring factory settings
68
English
Green Red
Off On
Off Off
1/s On
Off On
1/s 0.1/s
0.1/s 0.1/s