Aiwa CX-ZR774 Mode D'emploi page 22

1
2
3
CLEAR
u,>
Press CLOCK, then press ENTER within 4
seconds.
Turn MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute starts flashing.
Turn MULTI JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from 00 seconds.
'+ and - are ako avai/ab/e instead of MULTI JOG.
*IISET k also available instead of ENTER.
To display the current time
Press CLOCK. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press
CLOCK,
then press within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
The unit can be turned off automatically at a specified time.
1
Press SLEEP on the remote control.
2 Within 3 seconds, turn MULTI JOG or press 44
or *to specify the time until the power is turned
off .
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
\
To check the time remaining until the power turns off
Press
SLEEP
once. The remaining time is displayed for 3
seconds.
To cancel the sleep timer
Press
SLEEP
twice so that "SLEEPoFF appears.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
22
ENGLISH