Publicité
Les langues disponibles
Les langues disponibles
4,5
2
*,W
In the Programmed
edit recording
function,
the tracks
can be
programmed
while checking
the remaining
time on each side of
the tape as the tracks are programmed.
The programmed
edit recording
will not start from a point halfway
in the tape. The tape must be recorded
on from the beginning
of
either side.
Use the remote control from steps 3 to 10.
1
2
3
4
5
Insert the tape into Deck 2.
Insert the tape with the side to be recorded
on first facing out
from the unit.
Press
CD and
load
the
disc(s).
Press EDl"r/CHECK twice.
"PFIGM EDIT" and "PRGM"
light up on the display.
PRGM
PRGM EDIT
When "Al" is displayed,
press
EDIT/CHECK again.
lPress the numbered buttons O-9 to designate the
Itape length.
"1 O to 99 minutes
can be specified.
Maximum
recording
Tape length
Tape side(A)
time for side A
~
Press DIRECT, then press one of the numbered
buttons
1-5 within 3 seconds
to select a disc,
Then,
press the numbered
buttons O-9 and +10
to program a track.
Exarnp/e.' To select the 10th track of disc 2, press
DIRECT
and
2.
then
+10
and
O.
Selected
track number
Programmed
track numbers
7
8
9
Press EDIT/CHECK
to select side B and program
the tracks for side B.
After confirming
B on the display,
repeat step 5.
Tape side B(reverse
side)
Press EDIT/CHECK
to select side A. Then press
./OREC/REC
MUTE and press <~
within 2
seconds to start recording.
The tape is rewound
to the beginning
of the front side, the
lead segment
is played through for 10 seconds,
and recording
starts.
When the last track programmed
for side A is finished,
Deck 2 enters
the recording
stop mode.
After entering
the
recording
mode, go to step 9.
Press EDIT/CHECK to display the program for the
second recording and turn over the tape in Deck 2,
"!3" is displayed.
10 Press
/0
REC/REC
MUTE,
then press
+>
within 2 seconds to start recording on the second
side.
To stop recording
Press
. Recording
and CD play stop simultaneously.
To check the order of the programmed
track numbers
Before recording,
press
EDIT/CHECK to select side A or B, and
press +
or >
repeatedly.
Disc
number
Program
number
Track number
Programmed
track numbers
To change the program of each side
Press
EDIT/CHECK
to select side A or B, and press
CLEAR
to clear the program
on the selected
side. Then program
tracks
again.
To clear the edit program
Press
CLEAR twice so that
"EDl~
disappears
on the display.
Recording
is inhibited
if the erasure
presentation
tab for the
side of the tape facing out from the unit is broken off.
Up to 30 tracks can be programmed
from any of the inserted
discs.
ENGLISH
19
Publicité
