England's Stove Works 50-SHW03 Manuel D'installation Et D'utilisation page 40


Remember to check your local air quality forecast before you burn.
‐ Air Controls: SEE YOUR OWNER'S MANUAL for information on the Proper Use of Air
Controls (in the Operation section).
‐ ASH REMOVAL – Follow your Owner's manual's instructions regarding removal and
disposal of ashes.
‐ REPLACEMENT of parts that are critical to emissions performance – Follow your Owner's
manual's instructions regarding replacement of gaskets and other parts that are critical to
emissions performance.
Remember: "This wood heater needs periodic inspection and repair for proper operation. It is
against federal regulations to operate this wood heater in a manner inconsistent with operating
instructions in this manual."
More: Burner Tubes – To replace a tube, first be sure that you order the correct tube you need to
replace. Then using a 5/16" socket or open end wrench, remove the screw located on the left side
of the tube. Be sure to keep the screw. Push the tube to the right then remove the tube (pulling
the tube back to the left after that side has been removed from the hole). To replace, reverse the
above procedure...make sure to install the tubes in the correct order. (Front to Back)
‐ Smoke Detectors
England's Stove Works, Inc. highly recommends the use of smoke detectors in every room of the
house. However, locating a smoke detector directly above this unit can result in nuisance alarms.
This unit is meant to operate only with door closed. Smoke spillage and an inefficient, lazy burn
will result from attempting to operate the stove with the door open.
Additionally, using prohibited fuels can create an unsafe situation and can also generate excess
carbon monoxide. Carbon monoxide is an odorless, colorless gas which can be deadly.
The use of a carbon monoxide detector is strongly recommended.
Compliance: EPA Certified to comply with 2020 particulate emission standards using crib
‐
wood fuel.
CAUTION