Makita XTR01 Mode D'emploi page 9

1 2
► 1 . Shaft lock 2. Loosen 3. Tighten 4. Wrench
5. Collet nut
1
2
► 1 . Wrench 2. Loosen 3. Tighten 4. Collet nut
NOTE: The shaft lock may not return to the original
position when you tighten the collet nut at the instal-
lation of the trimmer bit. The shaft lock returns to the
original position when you start the tool.
1
► 1 . Shaft lock
Installing or removing the trimmer
base
1. Open the lock lever of the trimmer base, then
insert the tool into the trimmer base aligning the groove
on the tool with the protrusion on the trimmer base.
3
4
5
3
► 1 . Lock lever
2. Close the lock lever.
1
3. Attach the dust nozzle to the trimmer base, and
then tighten the thumb screw.
4
► 1 . Dust nozzle 2. Thumb screw
To remove the base, follow the installation procedure
in reverse.
9 ENGLISH
1
1 2