Sharp PN-HS551 Manuel D'installation page 9

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
Turning on the main power
Main power switch
Off mode, when main power is off.
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main plug.
Turning Power On/Off
Turning power on/off
Press the POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
Green lit
Orange lit
Green flashing
* Standby mode when POWER SAVE MODE is set to ON.
Networked standby mode when POWER SAVE MODE is
set to OFF. Networked standby mode allows the monitor to
be turned on via network (LAN, RS-232C, and HDMI CEC).
• Setting the SCHEDULE flashes the power LED alternately
in red and orange in standby state.
[Rear view]
POWER button
Status Status of the monitor
Power on
Power off (Standby state*)
Input signal waiting state
[Front view]
Power LED
7
E