Publicité
Les langues disponibles
Les langues disponibles
4 ] Remove both tape strips holding the 7" round adapter, and put the adapter aside.
5 ] Remove the screw holding the 3¼" x 10" adapter/damper and put the adapter/damper aside.
6 ] Remove the parts bag taped in the lower left corner of the hood.
7 ] Using a 11/32" nut driver or socket, remove the lock nut retaining the flange of the right cover
NOTE: For 30 in.-wide hoods, slightly lift up the cover plate before sliding it towards the left to
10
Save this screw, it will be used later to hold the cover plate.
PARTS BAG
plate (shaded part on illustration below) to the inner back of hood (see inset). Remove the
right cover plate retaining screws (7 screws), then set the blower cover along with its screws
and nut aside.
remove it.
TAPE
TAPE
5
4
6
1
7
BACK OF HOOD
LOCK NUT
REMOVE
AND SAVE
THIS
SCREW
3
S
CREW REMOVED
2
5
IN STEP
Publicité
