Perel Tools EFL80FB MUSHROOM Mode D'emploi page 2

• Do not look directly into the light source as sensitive people may go into epileptic seizure if
they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is a light effect for professional use on stages, in discos, theatres, etc. This
device should only be operated with an alternating current of max. 230Vac/50Hz and is
designed for indoor use only.
• This device is not designed for uninterrupted operation. Frequent operation breaks will
prolong the life of your EFL80FB.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
Respect a min. distance of 50cm between the EFL80FB's light output and the illuminated
surface
• Secure the device with an appropriate safety cable.
• Do not use the device if the ambient temperature exceeds 45° C. The max. temperature for
the housing is 130° C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur will probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short-circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void
the warranty.
4. Installation
a) Installing or Replacing a Lamp
CAUTION : Only install a lamp when the device is unplugged from the mains and replace it if it
has been damaged in any way.
• The lamps can become extremely hot during operation, so you should let them cool down for
at least 10 minutes before replacing them
• Do not touch the halogen bulbs with your bare hands. Use a cloth to handle the lamps during
insertion and removal.
• Do not install lamps with a higher wattage as they generate higher temperatures than those
for which the device is designed.
• Use two lamps (230V/40W) with an E12 socket.
1. Unscrew the top of the housing where you will find the half ball with the coloured lenses.
2. Gently remove the half ball.
3. Remove the old lamp and insert the new one.
4. Carefully reposition the half ball.
5. Fasten the cover.
Note : Do not operate the device with an open cover!!
EFL80FB
Procedure
2 PEREL