Mitsubishi Electric CITY MULTI PAC-PH03EHYU-E1 Manuel D'installation page 9

8
[Fig. 8.1.0.3] Right side
<A>
<A>As with <A> and <B> in [Fig.8.1.0.1], remove the water-proof cap from the unit wiring connector.
<B>Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<C>Connect the panel heater wiring and the unit wiring, and run the connected wiring between the fin
guard and the pillar.
<D>As with <E> in [Fig.8.1.0.1], place the cover back and fix the cover with the tie band.
A Unit wiring
B Cover
C Panel heater wiring
D Fin guard
E Pillar
F Tie band
[Fig. 8.1.0.4]
A
D
<B> C
B
<A>Screw down the metal sheet wiring cover and the fin guard
A
A Fin guard
B Cover wiring 1
C Cover wiring 3
<A>
B
C
8.1.0
A
<C>
E
at three points.
D
A
F
<D>
B
<D>
E
C
9