Mitsubishi Electric CITY MULTI PAC-PH03EHYU-E1 Manuel D'installation page 13

8
[Fig. 8.1.1.3]
Right side
<A>
<A>As with <A> and <B> in [Fig. 8.1.1.1], remove the water-proof cap from the unit wiring connector.
<B>Pull up the panel heater wirings and relay wirings so that the wirings run along the right rear pillar.
<C>Connect the panel heater wiring, the relay wiring, and the unit wiring, and run the connected wiring between the
fin guard and the pillar.
<D>As with <E> in [Fig. 8.1.1.1], place the cover back and fix the cover with the tie band.
<E>As with <F> in [Fig. 8.1.1.1], wrap the cover around the connector connection and fix it with the tie band.
A Unit wiring
B Cover
C Panel heater wiring
D Relay wiring
E Fin guard
F Pillar
G Tie band
H Cover (Supplied)
A
E
D
<B>
B
C
<B>
8.1.1
A
<C>
F
D
<C>
D
C
A
G
<D>
B
<D>
E
G
<E>
H
<E>
13