Klarstein JET SET 4000 Mode D'emploi page 25

TROUBLESHOOTING
Problem
The timer knob does not
turn.
The laundry drum does not
rotate.
No hot air is blown out.
The laundry has not been
dried properly.
The dryer will not start.
Possible cause
The plug was not inserted
correctly.
The door is open.
The plug was not inserted
correctly.
The socket does not supply
power.
The controller has been set
incorrectly.
The front and rear filters
are dirty.
Too much laundry in the
dryer.
Laundry was added while
the dryer was already
running.
The laundry has become
knotted while drying.
The dryer is in a place with
poor air circulation.
The regulator has been set
to Anti-wrinkle.
The door is open.
The plug has not been
plugged in properly.
The regulator is set to
"OFF".
Solution approach
Insert the plug firmly into
the socket.
Close the door.
Insert the plug firmly into
the socket.
Check the power outlet.
Set the controller to "Hot".
Clean the filters.
Reduce the amount of
laundry.
Dry the laundry again.
Unknot the laundry and
dry it again.
Place the dryer in a place
with good air circulation.
Choose a hotter setting.
Close the door.
Insert the plug firmly into
the power outlet.
Set the desired drying
temperature.
EN
25