Publicité
Les langues disponibles
Les langues disponibles
Installing the appliance
1.
Remove cover (1).
Apply the cover strips to the leading edge of
the appliance housing on the left and right.
2.
Adjust the height of the appliance to 4 mm less than the recess
height by turning the adjustable feet clockwise.
Turn the spanner anticlockwise to raise the appliance front and
clockwise to lower it.
Position the spanner accordingly
Important
The appliance must be aligned horizontally and vertically.
If the appliance is not level, the main body of the appliance
can be deformed and the door will not close properly.
EN-04
1.
2.
3.
Slide in the appliance until the front surface of the appliance door
is flush with the unit fronts.
When sliding in the appliance, make sure that the mains
cable is not damaged!
4.
3.
4.
• Screw the appliance to the
body of the unit at the top left-
hand side.
• Click cover into place again.
Publicité
