Dometic PERFECTVIEW M75L AHD Instructions De Montage Et De Service page 18

Using the LCD monitor
8 Using the LCD monitor
8.1 Switching on the monitor
➤ If the monitor is switched off, press the P button (fig. 0 2, page 5) to switch the monitor on.
➤ The button lights up green.
✓ The picture appears.
8.2 Switching off the monitor
➤ Press the P button (fig. 0 2, page 5) to switch off the monitor.
➤ The button lights up red.
✓ The picture disappears.
8.3 Setting the monitor
To set the monitor to suit your requirements, proceed as follows (fig. 0, page 5):
➤ Press the "
" button (5) to call up the required parameter.
✓ The parameters to be set appear in the following order:
Page 1: Picture
– Brightness: 0 – 100
– Contrast: 0 – 100
– Colour: 0 – 100
– Volume: 0 – 100
– Auto Dim On, Off
Page 2: Options
– Language: German, English, French, Italian, Dutch, Spanish, Portuguese, Russian
– Camera 1/Camera 2/Camera 3: Normal or Mirrored
– Sensitivity: 1, 2
Setting of the switching threshold for the night dimmer function to avoid glare.
In dimming mode, the switching threshold can be set at two levels.
– Trailer detection ON/OFF: Shortens the activation time in OFF mode
Page 3: Default
– Reset ("Default"): Default setting for all parameters
➤ Press the "+" button (3) or the "–" button (4) to set the required parameter.
➤ Press the "+" button (3) to increase the value of the selected parameter.
➤ Press the "–" button (4) to reduce the value of the selected parameter.
8.4 Setting the video source
Proceed as follows to set the video source (fig. 0, page 5):
➤ If you would like to switch to a different video source, press the "CAM" button (6).
✓ The monitor changes the camera in the order "Camera 1 – Camera 2 – Camera 3".
18
M55L AHD, M75L AHD
EN