Publicité
Les langues disponibles
Les langues disponibles
5
Troubleshooting
WARNING
• NEVER attempt to repair the operating console yourself.
• For failures of the operating console, you need to contact your specialist dealer.
He/She decides if the console needs to be reprogrammed.
In case of failure, a fault code is displayed by the blinking LED in the ON-OFF button or by a
triangle on the touch screen, see Figure 3.
The following table summarises the possible fault codes. Some problems can be solved by
yourself. For all problems marked in grey, consult your specialist dealer.
Table 2: Troubleshooting
Code
Problem
Remote / joystick error
1
Network or configuration
2
error
Left motor
(or its connection)
3
is defective.
Right motor
(or its connection) is
4
defective.
Left parking brake
(or its connection)
5
is defective or neutral
active.
Right parking brake
(or its connection)
6
Is defective.
Module error
7
(other than Remote)
Risk of injuries and damage to the operating console or wheelchair
Meaning
Verify that the joystick is in the neutral position when switching
ON the operating console.
Check the joystick: not damaged and working properly.
1. Check all connection points and cables.
2. Verify the correct working of the software.
If you cannot find any fault, contact your specialist dealer.
1. Verify whether the plugs of both motors have been inserted
properly.
2. Check the plug contacts of both motors for corrosion or
damage.
This fault also appears when the motors are disconnected.
Connect again and restart the system.
As described above.
1. Verify whether the motors' plugs have been inserted properly.
2. Check the plugs for corrosion or damage.
As described above.
One of the wheelchair parts may be damaged except the operator
control.
15
EN
LiNX 400
2021-09
Troubleshooting
NL
Publicité
