Publicité
Les langues disponibles
Les langues disponibles
the WMB-6 RGB 10mm LED Bar, you can select up to 14 different chasers.
Selecting a chaser
Press the SET UP button. Select the desired chaser (00 – 14) via the UP or DOWN buttons
Select the desired chaser value via the UP or DOWN buttons. (Step Time/Sp oder Flash Speed/Fs)
Fs (Flash Speed) from 00 to 100%.
Sp (Step Time) from 001 to 100 times/minute.
The desired values can be selected via the UP or DOWN buttons.
AUTO MODE
In Auto Mode the chasers are called up automatically in a continuous loop.
The desired frequency of the loops can be selected via the UP or DOWN buttons.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the WMB-6 RGB 10mm LED Bar will respond to the controller.
Addressing
Press the SET UP button until the display shows „DMX MODE dmx address:001".
Set the desired address via the UP or DOWN buttons.
Controlling:
After having addressed the WMB-6 RGB 10mm LED Bar, you may now start operating it via your lighting
controller.
Note:
After switching on, the WMB-6 RGB 10mm LED Bar will automatically detect whether DMX 512 data is
received or not. If the data is received, the control LED flashes. If there is no data received at the DMX-input,
the control LED lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of WMB-6 RGB
10mm LED Bar.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-Channel Selection: Choosing a DMX-Channel Mode
Press the SET UP button until the channel modes appear on the LCD display. („channel num: 20, channel
num: 11, channel num: 8, channel num: 5")
Set the desired mode via the UP or DOWN buttons.
If the DMX value is less than 251, then the Dimmer occupies the first channel and the Flash occupies the
second channel.
21/46
51930285_V_1_0.DOC
Publicité
