EuroLite WMB-6 RGB Bar 10mm LED Lighting Effect Mode D'emploi page 18

DESCRIPTION
Features
Extreme illuminating power in a compact luminary!
• 6 spots in one bar
• Equipped with 330 x 10 mm LEDs (red: 18x6, green: 18x6, blue: 19x6)
• Particularly bright illuminating power of the LEDs
• 14 internal programs
• Programmable color-change speed, strobe effect, and fading time
• RGB color-mixing
• DMX address selectable via 2 x 16 character LCD display
• 5, 8, 11, 20 DMX channels selectable for various applications
• DMX-512 control possible via any commercial DMX-controller
• Master/Slave function
• Rugged housing and an appealing design
• Ideal for bands, stages or solo entertainers
• Perfect in public places, main halls, lounges
• Ready for connection with safety-plug
• Locking possibility at the mounting bracket
• Advantages of LED-technology: extremely long life of the LEDs, low power consumption, minimal heat
emission, defacto maintenance free with brilliant light radiation
INSTALLATION
Overhead rigging
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
18/46 51930285_V_1_0.DOC