Black & Decker SS12 Mode D'emploi page 8

OPERATING INSTRUCTIONS
TRIGGER SWITCH & REVERSING BU'rFON
The drill is turned ON and OFF by pulling
and releasing the trigger switch (1). The
farther the trigger is depressed, the higher
the speed of the drill.
A forward/reverse control button (2)
determines the direction of the toot and
also serves as a lock off button.
To select forward rotation, release the
trigger switch and depress the
forward/reverse control button to the left.
To select reverse, depress the
forward/reverse control button the
opposite direction.
NOTE: The center position of the control
button locks the toot in the off position.
When changing the position of the control
button, be sure the trigger is released.
FIGURE D)
O
TORQUE CONTROL (SMART SELECT TECHNOLOGY) (FIGURE E)
This tool is fitted with a collar (3) which depicts various drilling and screwdriving
applications. They are used to select the operating mode and to set the torque for
tightening screws. Large screws and hard workpiece materials require a higher torque
setting than small screws and soft workpiece materials.
When the optimal performance selector collar (3) is rotated to any of the images shown in
the chart below, the toot shifts to deliver either the recommended torque or speed for that
application.
Driving 1/4 in.- 1 in.screws
Para colocar tornillos largos
de 6,35 rnm a 25,4 turn (1/4 pulg. a 1 pulg.)
Driving1 in. or longer screws MEDIUM TORQUE
Para coioear torniilos
do 25,4 mm (1 palg.) o rn-s Jargos MEDIA TORSI"N
Drilling 1/2 in. or larger drill bit into metal
Para eoiocar broca helicoidal de 12,7 mm HiGH T'OHQUE
(112puJg.) o m,sJargo en metal ALTA TORSJ"N
Driging 1 in.or largerspade bit HIGHEST TORQUE
Para eolocar broca de pala de 25,4 mm LA MAYOR TDRSI"N
(1 pol0.)o m.s lar ga en madora
TronsiDon from
SHIFT HIGH TORQUEtO HiGH SPEED
DAMD|O Transici0n de
ALTA TDRSI"N a ALTA VELDCiDAD
DriJJing up to 1/2 in,driJJ bit intoanymaterial
Paracoioear broea helicoidal de basra
HiGH SPEED
12,7 tool(1/2 pulg.) en coaJquier material ALTA VELODIDAD
HIGH SPEED
ALTA VELOCIDAD
HIGH SPEED
ALTA VELOCIDAD
Drilling3/8 in. or larger drill bit
into wcod or plastic
Para colocar broca helicoidal de9,5mm(3/8palg.)
o m.slargaonmadera o pl.stico
Drilling 7/8 in, spade or
smaller bit into wood
Paraeolocar broeadepala
de22,2mm(7/8pulg.)onmadera o m,speque0o
iiiiiiiii
iiiiiiiii