Connection
When handling an optical cable for wiring, use care not
to exceed the minimum cable bend radius of 30 mm.
If you exceed the minimum bend limit, optical fibers
within the optical cable may be damaged.
An Optical cable (Accessory 3) is fixed with a chassis using
harness band (Accessory ^). (KVT-817DVD only)
For the sake of safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking brake detection
switch harness using the supplied relay connector.
Ignition key switch
Car fuse box
(Main fuse)
Car fuse box
C
+
Battery
Antenna Cord
To Subwoofer system
Connect to the terminal that is grounded when either the
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
When using the optional power amplifier, connect to its power
To "EXT.AMP.CONT. " terminal of the amplifier having the external
4
|
English
30R
To vehicle's reverse lamp harness
To car light control switch
To Steering remote
A
ACC
A
B
B
C
FM/AM antenna input
Accessory 5
Accessory %
(KVT-817DVD only)
telephone rings or during conversation.
control terminal.
amp control function.
Optical output
(KVT-817DVD only)
Parking sensor wire (Green)
Reverse sensor wire (Pink)
Dimmer control wire (Orange/White)
Steering remote control input
(Light Blue/Yellow)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
AV INPUT 2
VIDEO
L
FM /AM ANTENNA
AV INPUT 1
VIDEO
L
Ground wire (Black) - (To car chassis)
C
Battery wire (Yellow)
B
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
External amplifier control wire (Pink/Black)
(Black)
PRK SW
REVERSE
ILLUMI
REMO.CONT
ACC
(5A)
BATT
Receiver unit (front side)
PRE OUTPUT
AV OUTPUT
REAR
FRONT
R
L
R-CAM V-IN
CENTER
L
L
SUB
VIDEO
R
R
R
R
[MONO]
Accessory 1
(10A)
MUTE
ANT CONT
P. CONT
EXT.CONT
Monitor unit
Accessory 4
POWER