Publicité
Les langues disponibles
Les langues disponibles
English
6.3. FUEL
IMPORTANT: The fuel used is highly
inflammable. If the fuel or the machine catch
fire, fight the flames with a dry dust fire extinguisher.
Do not smoke while preparing or refueling.
Do not approach any flame or hot element to
the fuel.
Use unleaded fuel of 95° and synthetic oil for 2 stroke
engines. Motor Fuel: Mixture (Gasoline 40: Oil 1) 2.5%.
Mix gasoline and oil in a bottle homologated for this
use. If you will mix more combustible just prepare
the amount you will use the short term. Do not use
fuel that has been stored over two months. The
fuel stored for long periods lose its characteristics
making it harder to start the engine and giving poorer
performance.
FILLING THE FUEL TANK
1. Choose an open are ato perform this situation
2. Stay away from the area where you have made the
preparation of the mixture.
3. Remove the combustible tank cap and fill with fuel.
4. Close tighly the fuel cap and remove all traces of
fuel that have been spilled with a rag.
WARNINGS:
- Always switch off the engine before refueling.
- Do not start the machine in a closed area. The
exhaust fumes and the vapours of the petrol all
contain carbon monoxide and other dangerous
chemical substances. In case of gas concentration
due to insufficient ventilation, eliminate from the
work area everything that impedes the correct flow
of air and do not work in this area again until it is
well ventilated and the gas concentration does not
happen again.
- Do not refill fuel in areas where flames, sparks or
hot sources are. Refill only in ventilated areas with
engine off. Do not overfill the fuel to try to overfill
the fuel tank. In case of fuel leakage, eliminate
these before starting the machine, do not attempt
to start the engine but move the machine away
from the area of spillage and avoid creating any
source of ignition until petrol vapours have
dissipated.
- Stay away at least 3 meters from the zone where
you have refueled before started the machine.
- Refill fuel before to start the machine. Do not
unscrew the combustible tank cap while the
engine is running or engine is hot.
- Do not use fuel with ethanol or methanol because
will damage the engine.
6.3.1. ENGINE OIL
For transportation reasons, your machine's engine
comes from the factory without any oil in it. Before
starting the engine for the first time you must put oil
the engine.
This engine uses quality oil for 4-stroke, 20w-40
viscosity.
The capacity of the engine's crankcase is 0, 6l.
Filling the oil sump:
- Place the machine on a flat, horizontal and
uncluttered surface.
- Unscrew the oil filler cap.
40/160
Publicité
