LENCO BT-191 Mode D'emploi page 8

in blue from slowly blinking.
4. Now, you can process for new mobile device pair or power Off the
Bluetooth Speaker if you wanted.
5. Notice: even disconnected Bluetooth for long time but it will be
reconnected when you come back to use this speaker.
E. Auto reconnect with paired device
1. Every time you turn On the Bluetooth Speaker's power; it will firstly
searching for the mobile device which has been paired previously and
and still in record;
2. The Bluetooth Speaker will reconnect this mobile device as priority if
it is in the Bluetooth searching device mode and in the
connection range.
3. If no device found in some seconds, then the Bluetooth Speaker will
automatically turn into the pairing mode.
4. Now you can process for new mobile device pair.
F. Use NFC for fast Bluetooth pairing
a. On Bluetooth Speaker:
1. Turn on the unit
2. Make sure that the NFC detection mark "NFC (4)" is at the right place
to touch.
b. On Mobile Phone:
1. Make sure that the mobile phone has the NFC function turned on
and the screen is active (unlocked).
2. Touch the mobile device NFC sensor on the Bluetooth Speaker's NFC
detection mark. Keep touching until the mobile device vibrates and
or sound. (When the devices connect, some mobile phone may pop
up a dialog box to confirm on it screen)
3. After pairing is successful; from Bluetooth speaker, a tones will
sound and the "Bluetooth(10)" LED will blink slowly in Blue
4. To disconnect the Bluetooth Speaker from an NFC connected phone,
touch it with the mobile device again.
Hint: If you cannot connect the unit, try the following:
•
Move the mobile phone slowly over the "NFC" mark of the Bluetooth
Speaker.
•
If the mobile phone is in case (especially metal), remove it from the
case.
7