DeWalt DXCMTE6590811 Guide D'utilisation page 23

GLOSSARY
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air
delivery.
PSI: Pounds per square inch; a unit of measure of pressure.
Code Certification: Products that bear one or more of the fol-
lowing marks: UL *, CUL, ETL
®
OSHA certified independent safety laboratories and meet the
applicable Standards for Safety.
* UL is a registered trademark of Underwriters Laboratories
®
and ETL is a registered trademark of Electrical Testing
®
Laboratories.
California Code: Unit may comply with California Code 462 (l) (2)/
(M) (2). Specification/model label is on the side of the air tank on
units that comply with California Code.
Unloader Blow-Off Pressure: All models are continuous running
units controlled by air tank pressure. When the maximum air tank
pressure is obtained, the unloader valve will blow-off. This will
cause the compressor to exhaust the air to the atmosphere and
not the tank. This decreases the load on the engine and allows it
to run at a near no-load condition.
Unloader Reset Pressure: When the air tank pressure drops to
a predetermined point, the unloader valve closes. The air tank
pressure will now increase until it reaches the unloader blow-off
pressure.
*, CETL, have been evaluated by
®
23