Oase AquaMax Eco Titanium 31000 Notice D'emploi page 32

NOTE
The unit will be damaged, if water enters the plug connector.
Connect the plug connector or place the protective cap on it.

 Ensure that the rubber seal is clean and fits exactly.
 If the rubber seal is damaged, it must be replaced. When the plug connector is disconnected,
the rubber seal must be replaced if it is older than 2 years.
 Always secure the plug connector or the protective cap with the two screws.
Submerged installation of the pump
• Ensure that the power cables and mains sockets are at least 2 m from the water.
• For installation of the pump in a pump chamber (recommended):
– For a swimming pond or pool frequented by swimming people, install the pump chamber at
least 2 m from the water.
– Install the pump horizontally.
– Screw the stand to the floor of the pump chamber to ensure the stability of the pump.
• For installation of the pump without a pump chamber:
– Place the pump horizontally on a stable, mud-free surface.
– Ensure secure and stable positioning of the pump.
• Only operate the pump when it is fully submerged.
• For muddy or soiled water, we recommend installing the pump or intake-side components
(skimmer, satellite filter, base outlet, etc.) above ground level. This decreases intake of parti-
cles and increases the service life of the impeller unit.
• Pool water or salt water can impair the appearance of the unit. Such impairments are excluded
from the guarantee.
32
PLX0004
AMX0063