BH FITNESS G6512 Mode D'emploi page 13

ERROR CODES
E01 Possible cable fault
E02 Motor failure
E03 No speed sensor signal
E04 Calibration error
E05 Possible motor overload
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
Connect the wire between top controller and
console.
Check the motor wires. Replace the motor if
necessary.
Check the position or replace the speed
sensor.
Change the control board.
a.- Lubricate the belt.
b.- Check that the motor is not burned.
c.- Check that the control board is not burned.
13