Haier HW90-B14CIN Mode D'emploi page 10

3-Control panel
3-9
Steam
3-10
Extra rinse
3-11
Extra rinse
Speed up
3-12
Delay
Note: Liquid detergent
If using liquid detergent, it is not recommended to activate the end time delay.
3-13
Start/Pause
3-14
Temp. Speed
3-15
10
If "Temp." button is pushed the "Steam" function will be
deactivated.You can activate "Steam" function only bef-
ore to start any programme. You cannot activate "Steam"
function while the appliance is already executing a programme.
3.5.4 Function button"Extra rinse"
Press this button (Fig. 3-10) to rinse the laundry more
intense with fresh water. This is recommended for
people with sensitive skin.
By pressing the button several times one to three ad-
ditional cycles can be selected. They appear in the dis-
play with P--1/P--2/P--3.
3.5.5 Function "Speed up"
This function saves time and energy. Preferable if laun-
Delay
dry is slightly soiled. Press simultaneously button "Extra
rinse" and "Delay" (Fig. 3-11) for about 3 seconds
to activate the "Speed up" function; SPEEd uP is dis -
played. This function is not available in all programmes
(see PROGRAMMES).
3.6 Function button "Delay"
Press this button (Fig. 3-12) to start the programme
with a delay. End time delay could be increased in steps
programme time).
end of programme cycle will be in 6 hours and 30 minut-
es.Press "Start/Pause" button to activate delay. It is not
applicable to programme Spin,Eco 40-60.
3.7 "Start/Pause" button
Press this button (Fig. 3-13) gently to start or inter
rupt the currently displayed programme. During pro
gramme setting and during programme run the LED
above the button is shining, or if interrupted blinking.
3.8 Child lock
Steam
Press button "Temp." and "Steam" (Fig. 3-14) for 3
seconds simultaneously to block all panel elements
against activation. For unlocking please press again
the two buttons.
The display shows
pressed, when the child lock is activated. The change
is not running.
(add time to the original
6:30 means
(Fig. 3-15) if a button will be
GB
-
-
-