Panasonic EY79A3 Instructions D'utilisation page 10

Original instructions: English
EN
Translation of the original instructions:
Other languages
Read "the Safety Instructions" booklet
and the following before using.
I. INTENDED USE
These tools can be used to tighten
screws in clutch mode and to drill
holes in wood and metal in drill mode.
Additionally, model EY79A3 can be
used to drill holes in soft concrete and
similar materials in hammer mode.
II. ADDITIONAL
SAFETY RULES
1) If the bit becomes jammed, immedi-
ately turn the trigger switch off to
prevent an overload, which can
damage the battery pack or motor.
Use reverse motion to loosen jammed
bits.
2) Do NOT operate Forward/Reverse
lever when the trigger switch is on.
The battery will discharge rapidly and
damage to the main unit may occur.
3) During charging, the charger may
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
4) Do not strain the tool by holding the
speed control trigger halfway (speed
control mode) so that the motor stops.
5) To prevent injury during use, hold the
tool steady at all times and avoid
waving it around.
6) Ensure that there are no hidden gas
or water pipes in the area in which
you will be working. Contact with
hidden pipes or wires could cause
electric shock or water or gas leaks.
7) Make sure to hold the object you are
working on steady.
8) Check for damaged parts.
• Check thoroughly for damage to the
protective cover and other parts
before operating.
• Check to make sure the tool and all
of its functions are working properly.
• Check the adjustment of all movable
parts, and check all fixed parts to
make sure they are fitted properly
and free of damage. Check all parts
of the tool for abnormal function.
9) When attempting to repair the protec-
tive cover or other parts, please follow
the instructions in the user manual. In
cases where there are no instructions
in the manual, please take it back to
the store to have it repaired.
10) If the tool gets exceptionally hot
during use, please take it in for
service and repair.
11) To avoid potential injury, keep face
and hands away from the drill bit and
any shavings.
12) Do not wear gloves when operating
the tool, as they may get caught by
the drill, leading to injury.
13) Battery terminals, screw shavings,
and tool accessories such as drill bits
will be very hot immediately after
operation. Do not touch them as there
is a risk of burning yourself.
14) Wear ear protectors when impact
drilling.
Exposure to noise can cause hearing
loss.
Symbol
(EY79A3 only)
- 10 -
Meaning
Volts
Direct current
No load speed
Revolutions or recip-
rocations per minutes
Electrical capacity of
battery pack
Rotation only
Rotation with
hammering
Read the operating
instructions before
use.
For indoor use only.