Panasonic EY79A3 Instructions D'utilisation page 14

Indicator
EN
3 lamps
illuminated
2 lamps
illuminated
One lamp
illuminated
3 lamps
flashing
Bit-locking Function
1. With the trigger switch not depressed
and a screwdriver bit locked in place,
the tool can be used as a manual
screwdriver (up to 22.6 N•m,
230 kgf•cm, 199 in•lbs).
2. This feature is handy for tightening
screws that require more torque than
the maximum torque of the driver
(position on the clutch), for confirming
the tightness of a screw or to loosen an
extremely tight screw. [Fig.8]
Changing the Belt Hook Location
Side [Fig.9]
The belt hook can be attached to either
side of the unit.
WARNING!
• Be sure to attach the belt hook securely
to the main unit with the screw firmly
fastened.
• Periodically check screw for tightness.
If found to be loose, tighten firmly.
• When the tool is held by the belt hook,
avoid jumping or running with it.
Battery status
Fully charged
or high charge
level
Approx. 60%
remaining
Low level
- Will require
charging soon
Empty
- Immediate
charging
required
- 14 -
WARNING!
• When the tool is hooked onto the waist
belt by the belt hook, do not attach
driver bits to the tool. A sharp edge
object, such as a drill bit, may cause
injury or an accident.
How to use spare bit storage
1. Store spare bits.
1 Remove the battery pack.
2 Push it all the way into the spare bit
storage as shown in [Fig.10].
2. Remove spare bit from storage. [Fig.11]
1 Remove the battery pack.
2 Pull out the bit tip on the rear side
of the spare bit and take out the bit.
Warning Functions
(1) Overheat Warning
Off Illuminated:
(normal Overheat
operation) (motor)
Indicates operation has been halted due to
motor or battery overheating.
• If the overheating protection feature
activates, allow the tool to cool thorough-
ly (at least 30 minutes). The tool is ready
for use when the overheat warning lamp
goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
• The performance of the EY9L42 deterio-
rates significantly at and below 10°C due
to work conditions and other factors.
Flashing:
Overheat
(battery)