Workshop WS0450VA0 Manuel Du Propriétaire page 8

CORD, HOSE & ACCESSORY STORAGE
Your Vac has convenient locations to
store your power cord, Vac hose, and
accessories.
Under the left cover of your Wet/Dry Vac
(as shown) is a storage location meant to
hold your expandable hose, crevice tool
and power cord. For ease of storage, the
hose should be folded as shown and
placed in the storage bin to the far left.
You will also notice a rectangular feature
in the bottom of this bin. The crevice tool
will easily store standing up in this
feature, tapered side down. Additionally,
the power cord will also fit in this bin to
the far right side. Fold or wrap the cord in
approximately 1-foot lengths until you get
within a foot of the storage bin. The folded
cord should now fit neatly into the storage
bin.
Under the right cover of your Wet/Dry Vac
(as shown) is a storage location for the
dusting brush and utility nozzle. Each of
these nozzles has a specific location
molded into the housing. Only these two
nozzles should be stored in this location.
Also located inside this compartment is
the blowing port. Please see the
"Blowing" section for blowing directions.
To store the extension wands, snap each
extension wand into the extension wand
clips on the back of the unit.
Correct
Hose
Wrap for
Storage
Hose
Storage
Crevice
Tool
Storage
Power Cord
Storage
Extension
Wand Clip
8
Blowing
Port
Utility
Nozzle
Storage
Dusting
Brush
Storage
Extension
Wand