Publicité
Les langues disponibles
Les langues disponibles
Filter
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
NOTE: This filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used for
wet or dry pick up. Handle the filter
carefully when removing to clean or
installing it. Creases in the filter pleats may
occur from installation but creases will not
affect the performance of the filter.
Cleaning A Dry Filter
NOTE: For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1 Light cleaning of some dry debris from
the filter can be accomplished without
removing the filter from the Vac. Simply
slap your hand on top of the handle
while the Vac is turned off.
2 Remove filter from Vac. Gently tap the
filter against the inside wall of your dust
drum and the debris will loosen and
fall.
3 For thorough cleaning of a dry filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.
Cleaning A Wet Filter
After filter is removed, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out
of your Vac. Replace it immediately.
Allow the filter to dry before reinstalling
MAINTENANCE
and storing the Vac.
Cleaning and Disinfecting the
Wet/Dry Vac
To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e.; waste water pick up) the drum
should be disinfected.
To disinfect the drum:
1. Pour 1 gallon of water and 1 teaspoon
2. Let solution stand for 20 minutes,
3. Empty drum after 20 minutes. Rinse
Cord Maintenance
When vacuuming is complete, unplug the
cord and store it properly under the left
cover (see "Cord, Hoses and Accessory
Storage" section on page 8). If the power
cord is damaged, it must be replaced by
the manufacturer to reduce the risk of
accident.
Storage
Before storing your Vac, the drum should
be emptied and cleaned. The cord should
be stored properly inside the unit and the
hose should be stored as described in
this manual. Accessories should be kept
in the same area as the Vac so they can
be readily available. The Vac should be
stored indoors.
12
and mild soap.
chlorine bleach into the drum.
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the drum.
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the drum.
Publicité
