Publicité
Les langues disponibles
Les langues disponibles
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight in out-
buildings or terraces/outside seating areas. If you are placing your appliance in an out-building such as
a garage or annex ensure that it is placed above the damp course, otherwise condensation will occur
on the cabinet. Never place the appliance in a wall recessed or into fitted cabinets or furniture
when it is working, the metal grid at the back may become hot and the sides warm.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal
alignment will be affected and may cause a malfunction. Once the
appliance is placed in its final location, adjust the leveling feet at
the front by turning them.
•
Turn the adjustable feet clockwise to raise the freezer
•
Turn the adjustable feet counter-clockwise to lower the
freezer
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it is working properly
and to allow it to reach the correct temperature.
Door right-left change
Depending on your needs, you can change the opening side of the door. You can choose to open it
from the right or from the left. To change the opening side, follow the instructions.
Warning:
▪
Before changing the opening side of the door, turn the appliance off and unplug it from the
mains.
▪
Any removed part must be kept until the end of installation.
▪
Do not lay the device down on the floor, you could damage the cooling system.
▪
Get help from one or two more people.
1. Power off the freezer and remove all objects from the door drawers.
2. Dismantle the hinge cover, screws and upper hinge, and remove the hole cap and pins from the
other side.
23
Publicité
