Publicité
Les langues disponibles
Les langues disponibles
- Adjust the alignment of the range hood using the screws on the brack-ets
(Fig. O2). The top screw (B) adjust the distance from the wall, the bottom
screw (C) adjust the height.
Step 3
- To avoid hood unhooking due to underneath pressure, fix it to the wall with a
screw anchor and related screw, by using the appropriate holes at the back
of the hood or the cope flasks.
Step 4
Place element (G) onto the chimney until is fully inserted.
- Fix the extension (H) to element (G), sliding it to the desired height.
- Once having found the optimum position, rest the bracket (L) against the
wall, check the hori-zontal alignment using a spirit level and mark the 2 holes
to be drilled at the ends.
- Drill the holes, insert 2 x 4mm dia. screw anchors and fasten the bracket (L)
using the corresponding screws.
- Tighten the extension (H) to the bracket (L) using the screws (M).
14
Publicité
