Publicité
Les langues disponibles
Les langues disponibles
2. Installation
2.1 Mounting the Automatic Transfer Switch (ATS)
Important: The ATS should be installed onto the rack rails in the lowest U space available
(height < 36 in./1 m).
Mount your equipment in a 4-post rack or rack enclosure. The user must determine the fitness of
hardware and procedures before mounting. If hardware and procedures are not suitable for your
application, contact the manufacturer of your rack or rack enclosure. The procedures described in this
manual are for common rack and rack enclosure types and may not be appropriate for all applications.
Note: Each snap-in slide rail assembly consists of a sliding rack enclosure mounting bracket and an inner
channel rail. For ease of installation, the inner channel rails come pre-attached to the ATS unit.
1
Align the rear bracket's tabs with the rack
enclosure's square mounting holes and
push the metal hooks through the
mounting holes
bracket toward the enclosure support for
the blue tabs snap the mount into place
. Then align the front bracket's tabs
1B
with the rack enclosure's front square
mounting holes. Push the front bracket's
metal hooks through the mounting holes
and push the front bracket toward the
enclosure support for the blue tabs to
snap the mount into place. Make sure
to install the mounting bracket into
the lowest U space.
2
Repeat step one for the second mounting
bracket on the opposite side of the rack
enclosure.
3
Once both mounting brackets are fixed
onto the rack enclosure, secure the rear
brackets using the included M5X10L
screws.
4
Align the inner channel rails attached to
the ATS with the mounting brackets. Then
slide the unit into the rail assembly. Using
a screwdriver, secure the ATS's panel-
mounted thumb screws to the rack
enclosure.
21-03-404-933363.indb 3
21-03-404-933363.indb 3
. Then push the rear
1A
1A
1B
3
4
3
4/1/2021 1:09:30 PM
4/1/2021 1:09:30 PM
Publicité
