Publicité
Figure 4
Page 26
How To Attach The Auxiliary Floor Tool
NOTE: When using "Wash & Rinse" units, NO soap will be
dispensed through the accessory connection.
To attach the auxiliary floor tool, follow this procedure:
1. Remove the vacuum hose from the recovery tank.
2. Connect the auxiliary floor tool vacuum hose to the
recovery tank and to the auxiliary tool.
3. Connect the solution hose to the machine and to the
floor tool.
4. Turn the vacuum/accessory switch "I".
5. Operate the optional cleaning tool as normal.
6. When finished cleaning with the optional floor tool, turn
the vacuum/accessory switch "O".
NOTE: Auxiliary floor tools recommended for this machine -
19209A - RM4 (Upholstery)
19212A - RM9 (9" Floor Wand)
785401 - RM10 (10" Floor Wand)
59220A - Plastic Hand Tool 4" (Upholstery)
MAINTENANCE
WARNING: Maintenance and repairs must be done
by authorized personnel only. Keep all
fasteners tight. Use only Clarke Technol-
ogy parts. Maintenance performed by
someone other than a Clarke Technology
distributor or Clarke Technology replace-
ment parts could void your warranty.
WARNING: Operating a machine that is not com-
pletely or fully assembled could result in
injury or property damage. Do not oper-
ate this machine until it is completely as-
sembled. Inspect the machine carefully
before operating.
NOTE: For maintenance of the optional floor tools, read
the manual supplied with the tools.
After Each Use Of The Machine:
1.
To prevent damage to valves and jets, flush one gallon of
clean water through the solution system and the tools.
2.
To prevent damage to the bristles, raise the brush off of the
floor by placing the brush height adjustment in the highest
slot.
3.
Disconnect the power cord from the outlet.
4.
Drain the recovery tank.
5.
Rinse out the recovery tank.
6.
Use a dry cloth to wipe both tanks and tools, inside and
out.
7.
Inspect and clean the screen filter at the rear of the ma-
chine. To remove the filter, turn the filter counterclockwise.
To install the filter, turn the filter clockwise.
8.
To prevent clogged jets due to alkaline buildup, the spray
system should be flushed at least twice a month with either
a white vinegar solution (one quart vinegar to one gallon of
hot water) or an anti-browning solution (mixed as directed).
9.
Remove any lint on the vacuum intake screen. The screen
is located behind the recovery lid and on the end of the
stand pipe. (See Figure 4)
CLARKE TECHNOLOGY Operator's Manual - Image 20 230V
Publicité
