Publicité
Introduction and Machine Specification
The Image 20 is an extractor for cleaning the carpet. The machine applies cleaning solution to the carpet and
removes dirty solution and soil from the carpet. The Image 20 is equipped with a power brush. The extractor has
controls to start the solution pump, and vacuum motor. The extractor (floor spray and brush) can be operated
intermittently or continuously. This machine is intended for commercial use.
NOTE: When using the extractor to clean carpets, follow this procedure:
1. Do not walk on freshly cleaned carpets for at least four hours or until the carpet is dry to touch.
2. If aluminum or plastic pieces have been placed under the legs of furniture, do not remove them until
the carpet is dry.
3. Do not allow children or pets to crawl or walk around on the damp carpet.
4. Vacuum right after the carpet is dry and then vacuum the carpet once a week, or as often as needed.
CLARKE TECHNOLOGY Operator's Manual - Image 20 230V
Specifications:
Model
Code Number
Solution Pump (bar)
Solution Tank Capacity (L) 26.5
Recovery Tank (l)
Waterlift (m)
Vacuum (W)
Electrical
Power Cable(m)
Spray Jets
Brush Size (cm)
Brush Motor Size (w)
Dimensions (cm)
Weight (kg)
Shipping Weight (kg)
Sound Level (dBA)
Vibration (m/s/s)
Soap Delivery
Soap Storage Volume
04117B
Image 20i
STD-230V
04117B
0 - 6.9 (Variable)
26.5
2.9
1200Tangential discharge 1200 Tangential discharge
230 Volt 50/60 Hz
11 3-wire
5 fixed front, 2 Q.C. rear Q. C. 5 front, 2 rear
7.6 x 40.6
187
84 x 117 x 51
51
65
85
<2.5
2 oz / gallon
.5 gallon
04118B
Image 20ix
DLX-230V
04118B
0-6.9 (Variable)
26.5
26.5
2.9
230 Volt 50/60Hz
23 3-wire
7.6 x 40.6
187
84 x 117 x 51
51
65
85
<2.5
2 oz / gallon
.5 gallon
Page 11
Publicité
