Télécharger Imprimer la page

Napoleon Entice Serie Manuel D'installation Et D'opération page 16

Publicité

Les langues disponibles

Les langues disponibles

installation
EN
3.4
recessed installation
Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
note:
It is recommended the walls of the appliance enclosure be fi nished (i.e. drywall) to avoid exposed insulation or
vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is maintained.
A.
Select a location that is not prone to moisture and is located at least 36" (94.1cm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
B.
Refer to framing dimensions and create a rough-in frame with electrical supply (see "framing" section).
C.
Remove wall mount bracket(s).
D.
Remove the front glass (see "front glass removal" section).
E.
Hold the appliance up to ensure it will fi t into the frame.
3.4.1 partially recessed installation
A.
Install the framing brackets by aligning the fl ange on the fi nishing material, and 5 1/16" (128mm) from the
bottom of the framing opening (Fig. 3-7).
B.
Remove the side holding brackets by removing the screws from inside the appliance (Fig. 3-8).
C.
Remove the power cord and complete hardwiring (see "hardwiring installation" section).
16
W415-4155 / - / 05.10.23
Side Holding
Brackets
Flange
5 1/16"
(128mm)
Framing hidden
for clarity.
Fig. 3-8
A x 4
Finishing
Material
Fig. 3-7

Publicité

loading