HomeMatic IP HmIP-BBL-I Notice D'installation Et D'emploi page 37

1x long green flash Transmission con-
1x long red flash
Short orange flash-
ing (every 10 s)
6x long red flashes Device defective
1x orange and 1x
green flash
9 Restoring factory settings
The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
• Remove the rocker (if necessary).
• Press and hold down the system button (A) for 4 s with a pointed
object (e.g. a pen) until the LED will start flashing orange quickly
(see figure 10).
• Release the system button.
• Press and hold down the system button again for 4 seconds, until
the LED lights up green (see figure 11).
• Release the system button again to conclude the procedure.
The device will perform a restart. After the restart, you can again integrate
your device into your Homematic IP system.
firmed
Transmission failed
or duty cycle limit is
reached
Pairing mode active Enter the last four numbers
Test display
Restoring factory settings
You can continue operation.
Please try again (see „8.1
Command not confirmed"
on page 35 or see „8.2
Duty cycle" on page 36).
of the device serial num-
ber to confirm (see see „6.4
Pairing" on page 34).
Please see your app for er-
ror message or contact your
retailer.
You can continue once the
test display has stopped.
37