Télécharger Imprimer la page

HomeMatic IP HmIP-BBL-I Notice D'installation Et D'emploi page 33

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
Permitted cable cross sections for connecting to the device are:
Rigid cable [mm
0.75 – 2.50
6.2
Installation overview
Homematic IP
Homematic IP
Shading Actuator
Switch Module for
for brand switches
brand switches
6.3
Installation
To remove an existing switch, follow the instructions of the respec-
tive switch manufacturer.
To install the Shading Acutator, proceed as follows:
Switch off the circuit breaker for the power circuit (see figure 2).
Place a suitable adapter on the Shading Acutator and screw it
tight using the enclosed screws (see figure 4). For further details
on installation, refer to the operating instructions for the adapter.
Connect the Shading Acutator as required according to figure 3
Loosen the screws of the flush-mounted box and screw the box
slightly outwards.
Insert the Shading Acutator with the mounted adapter onto the
screws in the flush-mounted box and screw the screws back in
(see figures 5+6).
]
flexible cable with/without ferrule [mm
2
0.75 – 2.50
Corresponding
Suitable
adapter
adapter
Frame
Frame
(example)
(example)
Start-up
]
2
Rocker
Rocker
(example)
(example)
33

Publicité

loading