Start-up
Consult an electrician!
*Specialist knowledge required for installation:
•
The following specialist knowledge is particularly important dur-
ing installation:
•
The "5 safety rules" to be used disconnect from mains; safegu-
ard from switching on again; check that no voltage is present in
system; earth and short circuit; cover or cordon off neighbouring
live parts;
•
Select suitable tool, measuring equipment and, if necessary, per-
sonal safety equipment;
•
Evaluation of measuring results;
•
Selection of electrical installation material for safeguarding shut-
off conditions;
•
IP protection types;
•
Installation of electrical installation material;
•
Type of supply network (TN system, IT system, TT system) and
the resulting connecting conditions (classical zero balancing,
protective earthing, required additional measures etc.).
The device may only be installed in the following commercially
available switch boxes (device boxes):
• According to DIN 49073-1
• Batibox-type switch boxes from Legrand
• Agro flush-mounting back boxes
The device can only be used with tube motors that have have inte-
grated obstacle detection.
Please observe the hazard information in section see „2 Hazard infor-
mation" on page 27 during installation.
32