Publicité
Les langues disponibles
Les langues disponibles
Start-up
•
Place the frame of your switch series on the Shading Acutator
(see figure 7).
•
Insert the rocker into the frame (see figure 8).
•
Switch the circuit breaker of the power circuit back on again.
•
The Shading Acutator is now ready for operation and can be con-
nected to the Homematic IP access point (see see „6.4 Pairing"
on page 34).
6.4
Pairing
Please read this entire section before starting the pairing proce-
dure.
First set up your Homematic IP access point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the operating manu-
al of the access point.
You can connect the device either to the access point or to the
Homematic Central Control Unit CCU3. For detailed information,
please refer to the Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.
To integrate the device into your system and enable it to communi-
cate with other Homematic IP devices, you must first add the device
to your Homematic IP access point.
To add the device, please proceed as follows:
•
Open the Homematic IP app on your smartphone.
Select the menu item "Add device".
•
•
After installation, the pairing mode remains activated for 3 min-
utes.
If the time has exceeded, you can manually restart the pairing mode
for another 3 minutes by removing the rocker and pressing the sys-
tem button (A) briefly with a pointed object (see figure 9).
•
Your device will automatically appear in the Homematic IP app.
•
To confirm, enter the last four digits of the device number (SG-
34
Publicité
