Publicité
Les langues disponibles
Les langues disponibles
3. PREPARE THE INSTALLATION
Make sure the following items are included:
- Hood
- Filters (2)
- Adapter/damper assembly 3¼'' x 10'' (located inside the hood, under the bottom panel)
- Compact fluorescent lamps (120 V, 13 W, PLC13, 2700 K with G24q-1 base) (packed behind the light diffuser)
- Bag of parts (located inside the hood, under the bottom panel) including:
(1) wire clamp, (5) no. 8 x 1/2'' double thread screws, (2) wire connectors and (6) no. 6 x 1/2'' screws
Part sold separately:
- Transition 3¼"x 10" to 6" round (optional, for 6" round ducts installation only)
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: If the bottom of the cupboard is recessed, attach wood strips (not included), as shown
beside, in order to properly install the range hood under the cabinet. The wood strips
must be as thick as recess.
Cut-out the openings for duct (A) and power cable (B), in cabinet or wall, according to the direction of discharge chosen.
See figures below.
H
ORIZONTAL DISCHARGE
A
3½"
5¼" 5¼"
HD0150A
4. PREPARE THE HOOD
Remove both filters from the hood. Disassemble the adaptor/damper (A) from the
hood.
NOTE: The adapter/damper is located inside the hood. Remove the bottom panel (B)
to access the adapter/damper. Refer to figure beside.
:
C L
1 8
"
11
7
"
8
B
1¼" dia.
CAUTION
V
ERTICAL DISCHARGE
CABINET BOTTOM
A
3¾"
¾"
HD0151A
- 5 -
3 8
2
"
HO0002A
:
C L
10½"
¼
1
"
1½"
5¼"
5¼"
3 8
"
B
A
HO0091
B
Publicité
