Télécharger Imprimer la page

Krups CONTROL LINE BW442D50 Mode D'emploi page 4

Publicité

Les langues disponibles

Les langues disponibles

This appliance may be used by persons with reduced physical, sensory
or mental capabilities, or whose experience or knowledge is not sufficient,
provided they are supervised or have received instruction to use the
appliance safely and understand the dangers.
Children should be supervised to ensure that they do not play with the
appliance.
Keep the appliance out of reach of children.
Children should be supervised to ensure that they do not play with the
appliance.
Never heat the kettle when it is empty.
Never fill the kettle past the maximum water level mark, nor below the
minimum water level mark. If the kettle is too full, some water may spray out.
Your appliance is designed for residential use only.
KRUPS reserves the right to modify the characteristics or components at
any time in the interests of the consumer.
CAUTION: the safety precautions are part of the appliance. Read them
carefully before using your new appliance for the first time. Keep them in a
place where you can find and refer to them later on.
Remove all of the various packaging, stickers or accessories from both the inside
and outside of the kettle.
Adjust the length of the cord by winding it under the base. Wedge the cord into the
notch. (fig. 1)
Throw away the water from the first two/three uses as it may contain dust. Rinse the
kettle and the filter separately.
1. TO OPEN THE LID.
Press on the unlocking button. (fig. 2)
When you press on the unlocking button, the lid will open automatically.
The kettle will heat when lid is open. It will not turn off. If the lid is lost or broken,
please contact your after-sales service center.
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY
FROM WATER SPLASHES AND ANY SOURCES OF HEAT.
Your kettle must be used with the base and anti-scale filter specific to this product.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (fig. 3)
You can fill it up with water via the spout or directly into the kettle. (fig. 3)
Never fill the kettle when it is on its base.
Do not fill it above the maximum level, or below the minimum level. If the kettle is too
full, boiling water may spill out. (fig. 4)
Do not use without water.
Check that the lid is closed properly before use. (fig. 5)
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE SOCKET.
BEFORE FIRST USE
USE
3

Publicité

loading