Publicité
Les langues disponibles
Les langues disponibles
Prepare the Hood
NOTE: Since this manual covers many range hood models, some details in the following
illustrations may sligthly differ from your unit.
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup or tab, remove the grease filters from the hood by pushing down
tilting filter out
.
B
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap (no EZ1 brackets
in BCS3 and NCS3 Series). Remove both screws holding damper assembly to hood.
Remove parts bag (captured behind the damper assembly). Remove damper assembly from
inside the hood and keep the screws for further use.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.
C
and
SCR EWS
DAMPER
ASSEMBLY
11
Publicité
