Bergstrom SLIMFIT RENAULT T High Sleeper Cab 24 V Instructions De Montage page 17

SLIMFIT
- If during installation of the unit the cables pass
through walls with sharp edges, use conduits
or guides to prevent damage to the cables.
- If during installation the unit is tilted, or the cab
is tilted with the unit installed on top, you must
wait at least 60 minutes after placing the unit in
horizontal position before it is started.
- Unit pre-charged with r-134a refrigerant gas.
- Important: When connecting the unit make
sure the polarities are not reversed. If this
happens, the control board will not switch on
and the unit will not operate.
Tools required for assembly
- Torx wrenches set.
- Allen wrenches set.
- Open-jawed spanner 10, 13, 14.
- Scissors.
- Flexo-meter.
- Screwdriver.
Proper use of the product
- SLIMFIT is a roof-mounted air conditioning unit
suitable only for use in trucks. It is not suitable
for installation and operation in agricultural
or construction machinery subject to intense
vibrations.
- Non-intended use will void the unit's warranty
and exempts the manufacturer from any
responsibility.
- If you are not sure how to use SLIMFIT, read
the product's user manual.
- If the temperature in your vehicle's cab is
too high for rest, first cool the cab with your
vehicle's air conditioning for a few minutes
and then run SLIMFIT to maintain the comfort
temperature.
Associated documentation
- Quick guide: 1003115344
- User manual: 1003148646
- List of spare parts: 1003345687
- Troubleshooting: 1003148649
Dirna Bergstrom declares that the SLIMFIT unit
complies with the requirements of the following EC
Directives and that the harmonised standards and
technical specifications listed below have been
applied:
- EC Directive 2014/53/EU
- EC Directive 2011/65/EU
- EC Directive 2014/30/EU
17
EN