Nolangroup N-Com ESS III Mode D'emploi page 18

EN
3. SYSTEM INSTALLATION
Important: Prior to installing the N-Com system, it is recommended to write down the identification
code affixed to the product (see chapter 6.4).
Select the adaptor suitable for your helmet's shell (Fig. 1).
•
Affi x the ESS system to the adaptor (Fig. 2-3).
•
Remove the protective film from the double-sided adhesive tape (Fig. 4).
•
Apply the ESS system to the centre of the back of the helmet as shown in the diagram (Fig. 5-6).
•
Fig. 1
Fig. 4
6
Fig. 2
Fig. 5
Fig. 3
Fig. 6