Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
C-PHB-C-L2F-SCCT Series
With Emergency Backup
PENDANT MOUNT
(FOR FIXTURES WITHOUT FACTORY INSTALLED
6FT CORD)
NOTE: Fixture must be suspended a minimum of 12" below mounting
surface.
1.
Using a flat head screwdriver, remove the (2) outer 1/2" knockouts
from the top surface of the fixture. Be careful not to damage any
wires inside the LED driver compartment. See Figure 6.
2.
Using (2) 1/2" threaded conduit pendant stems (provided by
others), mount the fixture in the desired location:
• To attach pendant stems to fixture, the back cover of the
fixture must be removed by removing (8) screws. See
Figure 7.
• Two locknuts should be used on each pendant stem (one for
inside the LED driver compartment and one for outside). See
Figure 8.
• Once pendant stems are attached to fixture, reinstall back
cover by retightening (8) screws. See Figure 7.
3.
Remove screw from wiring access cover to allow for removal of
cover. See Figure 3.
4.
Conduit:
Insert leads from conduit through 1/2" knockout in wiring access
cover. Secure conduit to cover with conduit nut on opposite side of
the cover. See Figure 4.
5.
See Electrical Connections section for wiring.
6.
Replace wiring access cover. Make sure both ends of wiring
access cover are engaged with the top of the back cover. Secure
cover in place using screw removed in Step 3.
7.
Select the desired CCT and wattage using the dip switches on the
fixture back cover. See Figure 5.
NOTE: Factory settings are highest wattage and 4500K
PENDANT MOUNT
(FOR FIXTURES WITH FACTORY INSTALLED 6FT
CORD)
NOTE: Fixture must be suspended a minimum of 12" below mounting
surface.
1.
Using a flat head screwdriver, remove the (2) outer 1/2" knockouts
from the top surface of the fixture. Be careful not to damage any
wires inside the LED driver compartment. See Figure 6.
2.
Using (2) 1/2" threaded conduit pendant stems (provided by
others), mount the fixture in the desired location:
• To attach pendant stems to fixture, the back cover of the
fixture must be removed by removing (8) screws. See
Figure 7.
• Two locknuts should be used on each pendant stem (one for
inside the LED driver compartment and one for outside). See
Figure 8.
• Once pendant stems are attached to fixture, reinstall back
cover by retightening (8) screws. See Figure 7.
3.
Complete the wiring of the cord to the supply wiring per the
Electrical Connections section. .
4.
Select the desired CCT and wattage using the dip switches on the
fixture back cover. See Figure 5.
NOTE: Factory settings are highest wattage and 4500K
http://lighting.cree.com/warranty
Document
LPN00708X0002A0_A
Created By:
TMT
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
|
866.924.3645
Date:
1-19-2023
22.25"
22.25"
Publicité
