Assembly - Husqvarna 122C Manuel D'utilisation

Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten.
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To attach the cutting attachment guard
and the trimmer head (straight shaft)
1. Attach the cutting attachment guard (A) to the shaft
with the bolt (L).
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
4. Put a small screwdriver (C) in the hole to lock the
shaft.
L
A
1059 - 002 - 10.10.2019

Assembly

5. Turn the trimmer head (H) counterclockwise to
tighten the trimmer head to the gearbox. (Left hand
threads.)
To attach the cutting attachment guard
and trimmer head (curved shaft)
1. Attach the guard. Tighten the nut.
2. Attach the dust cup on the shaft.
3. Hold the dust cup with an adjustable wrench to make
B
sure the shaft does not turn.
C
4. Attach the trimmer head to the shaft. Turn the
trimmer head clockwise.
A
H
9