Operation - Husqvarna 122C Manuel D'utilisation

To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab (A) with the arrow (B) on the coupling.
3. Push the shaft into the coupling until it clicks into
position.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
10
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
B
A
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the engine is
attached to.
4. Pull the attachment straight out of the coupling.

Operation

Fuel
This product has a two-stroke engine.
C
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.
1059 - 002 - 10.10.2019