Elba N55 204 Série Mode D'emploi page 26

REPLACEMENT OF BURNER
INJECTORS
If the injectors are not supplied they can
be obtained from the "Service Centre".
Select the injectors to be replaced accor-
ding to the "Table for the choice of the in-
jectors".
To replace the injectors proceed as fol-
lows:
• Remove pan supports and burners
from the cooktop.
• Using a wrench, substitute the nozzle
injectors "J" (fig. 7.4) with those most
suitable for the kind of gas for which it
is to be used.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
ADJUSTING OF THE MINIMUM OF
THE TOP BURNERS
In the minimum position the flame must
have a length of about 4 mm and must re-
main lit even with a quick turn from the ma-
ximum position to that of minimum.
The flame adjustment is done in the fol-
lowing way:
• Turn on the burner.
• Turn the tap to the MINIMUM position.
• Take off the knob.
• With a small flat screwdriver turn the
screw inside the tap rod to the correct
regulation (fig. 7.5).
Normally for LPG, tighten up the regu-
lation screw.
26
GAS MAINTENANCE
Fig. 7.4
Fig. 7.5
J